LPG multivalves model AT11 are suitably developed for the applications on two-wheeler, with the withdrawal pipe set in vapour phase.
Homologated according to the ECE 67R-01 Regulation, multivalves model AT11 are designed for the specific use on the motorbikes. They are equipped with safety valve and thermo-fuse, integrated in one device, and an horizontal coil that allows the reduction of hindrance and the possibility to install the tank also under the seat of the motorbike.
The multivalve is also provided with 80% automatic filling stop (*), solenoid valve at the outlet, excess flow valve, non-return valve, manual (service) valve and set for the level indicator as well.
| Multivalvole AT11 technical data |
| Material |
Hot forged brass |
| Weight |
around 0.80 kg |
| PRV setting |
2,7 MPa (27 bar) - 2,2 MPa (22 bar) India |
| PRV flow rate |
7,2 Nm3/min |
| PRD flow rate |
4,4 Nm3/min |
| PRD melting point |
120 ± 10 °C |
| Inlet fitting |
1/4 gas |
| Outlet fitting |
M10x1 - pipe ř 6 mm |
| Coil voltage |
12 V DC |
| Coil absorption |
11 W |
| Solenoid valve type |
normal |
| Solenoid valve hole |
3 mm |
(*) As requested by the Regulation 67R-01 (Part II) the installer must verify during the lpg filling that the couple multivalve-tank and its positioning on the vehicle allow the correct functioning of filling limiter device, which has to activate within 80% of tank volume.
